Reese 63016 PINTLE HOOK User Manual download pdf

INSTALLATION INSTRUCTIONS

PLYMOUTH, MICHIGAN

BALL/PINTLE HOOKS

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY

OCCUR DUE TO OVER TIGHTENING.

WARNING: DO NOT DRILL OR WELD TO THIS HITCH.

IMPORTANT NOTES

USE ONLY CEQUENT SUPPLIED BOLTS, LOCKNUTS, AND

WASHERS TO INSTALL THIS HITCH.

N/A 60,00014,000Pintle Hook (30 Ton)63016

N/A 30,0006000Pintle Hook (15 Ton)63015

N/A 20,0004000Pintle Hook (10 Ton)63014

N/A 10,0002000Pintle Hook (5 Ton)63013

14,000 16,0003000Combination Pintle & Ball (2-5/16”)63012

10,000 16,0003000Combination Pintle & Ball (2”)63011

6,000 16,0003000Combination Pintle & Ball (1-7/8”)63010

Max Gross Trailer Weight (LB)

Ball Hitch Pintle Hitch

Max Tongue

Weight (LB)

DescriptionPart Number

WARNING: Do Not Exceed Vehicle, Pintle Mounting or Trailer Coupler Rating.

MOUNTING

1. Mounting structure must be capable of supporting the rated capacity of the pintle hook in accordance with SAE J847.

2. Use the 4 - 1/2" grade 8 bolts and torque to 100 ft. lbs.

3. For combination pintle hooks, torque ball locknut to 350 ft. lbs.

OPERATING INSTRUCTIONS

PINTLE HOOK

1. Open latch by removing safety pin and lifting latch.

2. Position drawbar eye over the horn of the pintle and lower into place.

3. Close latch and insert safety pin.

BALL HITCH

1. Open latch by removing safety pin and lifting latch.

2. Replace safety pin in hole to retain latch in open position.

3. Position ball coupler over ball and lock into place, following coupler manufacturer's instructions.

WARNING:

- Other steps and inspections are required. Consult D.O.T. regulations and American Trucking Association for

complete coupling and uncoupling procedures.

- Be careful with the drawbar when coupling and uncoupling to avoid damaging the latch.

- Maintain adequate vertical (tongue) load to properly control the trailer (approximately 10%) not to exceed

above rated capacities.

-For off-road applications, reduce the rated capacities by 25 percent.

- When loading/unloading a trailer coupled to the tow vehicle, support the rear of the trailer to avoid load shifting.

MAINTENANCE

1. Clean and inspect for proper operation every 30,000 miles or 3 months, whichever comes first.

2. Regularly lubricate latch and lock pivots with a light oil lubricant.

3. Periodically check all mounting bolts and ball locknut for proper torque.

4. Replace ball locknut if torque falls below 70 inch lbs. of torque required to thread onto ball shaft.

INSTALLATION INSTRUCTIONS 1

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

INSTALLATION INSTRUCTIONSPLYMOUTH, MICHIGANBALL/PINTLE HOOKSWARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY OCCUR DUE TO OVER TIGHTENING.WARNING:

Comments to this Manuals

No comments

Reese 63016 PINTLE HOOK User Manual

Browse online or download User Manual for For the car Reese 63016 PINTLE HOOK. Reese 63016 PINTLE HOOK User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Reese 63016 PINTLE HOOK