Reese 44629 PROFESSIONAL RECEIVER User Manual download pdf

Installation Instructions

Volvo XC60

Part Numbers:

87566

75671

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Bumper

Fascia

44629

Hitch Shown In Proper Position

Equipment Required: USE ONLY 8.5” LONG X

3/4” RISE X 2” DROP BALL MOUNT

Fastener Kit:

75671F

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

4,500 (2043 kg) 450 (204 kg)

Weight Carrying

Ball Mount

4,000 (1816 kg) 400 (181 Kg)

Wiring Access Location: SUV 3,4

Access hole

Step 7

Wrenches: 13mm, 11/16”

Drill Bits: none

Fishwire - provided

Tin snips

Fastener

Kit:

75671F

Exhaust

Foam tape

over holes

First

Step 5

hanger

Foam tape

over hole

Exhaust

isolator

Access hole

Forward

attachment hole

First

attachment

hole

Qty. (4) Bolt – carriage 7/16” – 14 x 1-1/2” gr 5

Qty. (6) Nut – 7/16” - 14

Qty. (2) Bolt – carriage 7/16” – 14 x 2” gr 5

Qty. (4) Block – 1/4” x 1” x 3”

Trim Heat Sheild

– both sides

Step 8

1. Raise vehicle.

2. Lower exhaust by removing rubber isolator from muffler support. Temporarily remove exhaust hanger for ease of heat shield trimming

and hitch installation.

3. Trim heat shield (both sides) with tin snips as shown above. Caution, edges are sharp.

4. Remove foam tape covering holes on the bottom and on the inside of the frame (shown above). Keep tape to cover unused holes.

Qty. (2) Block – 1/2” x 1-1/4” x 2-1/2”

Qty. (2) Block – 3/16” x 1” x 2”

Qty. (6) Washer – 7/16” conical

Qty. (2) Fish wire – 7/16”

5. Using the fish wire provided, install item 1 and 6 into location shown through access hole (both sides).

6. Gently lifting the rear fascia and slide hitch over exhaust into position. Raise hitch up to frame making sure not to push fasteners back

into frame. Loosely install conical washers and nuts.

7. Slide block item 3 between the hitch and frame on the forward attachment. Fish wire item 2 and 7 through access hole and through

forward attachment holes. Install conical washers and nuts as shown

8. Insert the coil end of fish wire through first attachment hole in hitch and into the frame. Angle the wire back so it comes out the end of

the bumper. Insert item 1 and 6 into the first attachment hole and install conical washers and nuts.

9. Pull hitch rearward as much as possible and tighten fasteners.

i t ll th ffl h d i t 2 R

tt h ffl t th bb i l t C t f t d d h l

e mu

ffl

anger remove

n s

e-a

ffl

e ru

ors.

oam

ape an

cover unuse

frame

z 2009 Cequent Towing Products

Sheet 1 of 3 75671N 7-15-09 Rev. A

Tighten all 7/16” fasteners with torque wrench to 50 Lb.-Ft. (68 n-m)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and

exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut

access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.

Form: F205 Rev A 5-6-05

1 2 3

Summary of Contents

Page 1 - Installation Instructions

Installation InstructionsVolvo XC60Part Numbers:8756675671Do Not Exceed Lower of Towing Vehicle Manufacturer’s Rating orBumper Fascia44629Hitch Shown

Page 2 - Instructions d’installation

Instructions d’installationVolvo XC60Numéros de pièces :8756675671Ne pas excéder les spécifications de poids du fabricant du véhicule de remorquage, n

Page 3 - Instrucciones de instalación

Instrucciones de instalaciónVolvo XC60Números de partes:8756675671No supere el valor inferior entre la calificación del fabricante del vehículo de rem

Comments to this Manuals

No comments

Reese 44629 PROFESSIONAL RECEIVER User Manual

Browse online or download User Manual for For the car Reese 44629 PROFESSIONAL RECEIVER. Reese 44629 PROFESSIONAL RECEIVER User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Reese 44629 PROFESSIONAL RECEIVER